Use 22mm regular wrench to secure the rear sensor, and either the same wrench or o2 sensor wrench for the front one

It is impossible to torque them by torque wrench there, so i just.

Typically that means putting the sensor between the 9:00 and 3:00 positions (e.g

Above the halfway line) on the pipe

Lower than that, and condensation can damage the sensor

Master the mechanical and electrical installation of a wideband o2 sensor to unlock precision engine tuning and reliable afr data.

Install the sensor 24 inches downstream of the exhaust manifold collector or 24 inches after the turbo

Position the sensor between the 9 o'clock and 3 o'clock positions in the.

Let's don't forget that the closer o2 sensor located to the head, the more sensitive it will be to changing ignition timing (up to 0.5 afr difference) whilst the actual air fuel mixture will stay the.

8 inches away from the exhaust port

The wide band sensor will no zontal to allow condensation runoff

Without this angle the sensor is significantly more likel try not to place the wbo2 on the outside of a.

Whether it's narrowband o2s or a wideband o2, proper o2 sensor placement is critical to the operation and tuning of an engine

In this tech tuesday, steve morgan gives a few tips to making.

Mount the o2 sensor on the top side of the exhaust pipe, ideally between the 9 o’clock and 3 o’clock positions

If you’re installing it on a curved.

In this tech tuesday, steve morgan gives a few tips to.