It has been engineered to greatly reduce shift throw and improve shifter feel

Check the parts list and tool lists at the beginning of these instructions for the supplied parts and the tools required to install.

It outlines 30 steps to remove the stock shifter and install the new shifter, including.

Next you'll need to remove the 3 bolts holding the transfer case shifter to the transmission (tj owners won't need to do this)

There are two bolts on top, one going into the side

Once you have the transfer.

I just finished installing a b&m 45195 short shifter in my 2014 jku

Following will be my first impressions of it along with notes, comments and.

Recently i replaced my shifter bushing because i had a lot of play and slop in my shifter

I drove my friends' jeep the other day and his felt very tight and notchy.

Following will be my first impressions of it along with notes, comments and photos from.

By the end of this article, you’ll have the knowledge and steps to understand, diagnose, and repair your jeep’s shift linkage, saving you time, money, and a whole lot of headache.

Pull the boot that covers the shifter shaft attachment to the shifter tower and tighten the torx bolt

Something else to inspect, inside the connection is a flat key, if it's no longer flat, that can.

In this episode of our 'project 6.0' (ls tj series), we install a short throw shifter

This is a very economical and easier alternative to more expensive shifters

Due to having to move the.

After 6 months of having the b&m short shifter i decided to do the install and made a video for those of you that might be thinking of installing one.

It shortens the shift throw by 30% or so and like others have said it does so by changing the fulcrum point

Therefore it has no effect on your synchros or anything else like that

I wasn't able to shift from 2nd to 1st unless the jeep wasn't rolling

The symptoms started with grinding, then progressed to no go while in motion

The stock shift finger had a wear worn gouge.

In short, the best solution for your shift lever interference issue is to raise the rear of the drivetrain via a tummy tuck

Be aware that this will effectively increase the operating angle of your.