Now i am attempting to do the clutch bleeding procedure in ista
It makes some noise, takes about 7 to 8 minutes and then results in an error saying
If no air bubbles escape, close bleeder valve (1), otherwise repeat procedure.
I had issues putting my m5 into gear after replacing my clutch/hydraulic system, so i really needed to bleed my system well
So i did a lot of methods in order to resolve these.
21 00 006 bleeding clutch hydraulic system special tools required
• 21 5 030 necessary preliminary tasks
• remove transmission underbody protection if necessary
• remove microfilter housing is.
After rebuilding the smg iii hydraulic unit and replacing pretty much everything inside bellhousing, bleeding, clutch teaching and clutch slip point just me taught into the smg control unit.
I was able to successfully bleed my clutch by opening the bleed nipple on the slave cylinder, and fully pressing and lifting (slowly) the pedal twice, then refil the reservoir, then pressing.
One round of bleeding the slave cylinder is complete when your friend lifts their foot off of the clutch pedal
With the bleed valve closed and your friend’s foot off of the pedal, open the brake fluid reservoir on the master cylinder and add brake fluid to it to ensure it doesn’t run dry as you go.
Home / bmw e60 m5 sedan / repair manuals and technical data / 23 manual gearbox / 23 00 manual gearbox /