Jza80 toyota supra mkiv sockets & pins set for the main engine harness going to ecu
My wiring guy wants to replace mine as some of the pins are damaged and many are quite loose.
We ended up removing the tms harness completely so that the car was technically stock with no reflex box plugged in, and then we also repair any dme wires that were damaged from the t.
Valve cover upgrade + wire tuck i run a full carbon setup, but decided to have my wires tucked while getting a valve cover job done
Got the motiv harness replaced with one from tms, and the other harness was swapped as well
My tuner also confirmed that he has a good signal from the can input sensor, so i have.
This service bulletin provides parts information and repair procedures for wire harnesses, wire terminals, and connectors for.
Wire tuck advice by cainhead march 27, 2019 in supra chat share followers 0 reply to this topic start new topic
Pull the harness into the engine bay and route out behind wing (take all hard plastic covers off)
I wrapped mine in loom tape then i had to extend the 2wires on the plug that connects to the brake.
We went straight into the engine bay wiring harness to do a complete wire tuck and eliminate all the useless factory stuff.
Hi everyone, i have everything ready to go to change the spark plugs on my b48 engine
I have researched my question on this site as well as several you tube videos on b48 spark plug.